간행물
한국응용과학기술학회지 KCI 등재 The Korean Society of Applied Science and Technology
- 발행기관 한국응용과학기술학회(구 한국유화학회)
- 자료유형 학술지
- 간기 격월간
- ISSN 1225-9098 (Print)2288-1069 (Online)
- 수록기간 1984 ~ 2024
- 주제분류 공학 > 화학공학 공학 분류의 다른 간행물
- 십진분류KDC 575DDC 665
권호리스트/논문검색
Vol.20 No.3 (2003년 9월) 11건
1.
2003.09
구독 인증기관 무료, 개인회원 유료
4,800원
2.
2003.09
구독 인증기관 무료, 개인회원 유료
In this study, we synthesized p-hexyloxybenzaldehyde(HBA) by using p-hydroxybenzaldehyde and n-hexylchloride. p-dodecylaniline(DDA) prepared by nitration and reduction of dodecylbenzene. The schiff base, p-dodecylbenzylidene-p'-hexyloxyaniline (DBHA) was synthesized by reaction of HBA and DDA. The color of synthetic compound was pale-brown and the yield was 62%. All the synthetic compounds were identified by TLC, FT-IR and iH-NMR.In this study, we synthesized p-hexyloxybenzaldehyde(HBA) by using p-hydroxybenzaldehyde and n-hexylchloride. p-dodecylaniline(DDA) prepared by nitration and reduction of dodecylbenzene. The schiff base, p-dodecylbenzylidene-p'-hexyloxyaniline(DBHA) was synthesized by reaction of HBA and DDA. The color of synthetic compound was pale-brown and the yield was 62%. All the synthetic compounds were identified by TLC, FT-IR and 1H-NMR.
4,000원
3.
2003.09
구독 인증기관 무료, 개인회원 유료
Poly(oxypropylene-oxyethylene glycol) Block Copolymer계 유분산제의 제조와 Weathering Crude Oil에 대한 W/O 에멀젼 특성
Poly(oxypropylene-oxyethylene glycol) block copolymer(PBC) oil dispersant, which has low toxicity, high biodegradability, and an excellent dispersion efficiency to crude oils and weathered W/O emulsion was prepared by blending PBC, poly(oxyethylene) oleate, and sorbitan monooleate. The dispersing efficiency was measured by swirling flask method. The PBC oil dispersant had an excellent dispersing efficiency to weathered oil products formed as stable W/O emulsion, and the low toxicity, such as 4000 ppm to Oryzias Latipes(24 hr, TLM), Brine Shrimp Artemia(24 hr, TLM).
4,000원
4.
2003.09
구독 인증기관 무료, 개인회원 유료
Electrical properties of carbon filler/PVdF [poly(vinylidene fluoride)] composite were investigated as a funtion of carbon filler/PVdF ratio in the range of 0.2~0.5. Three kinds of comercialzied conductive carbon blacks such as Hiblack 41Y, KE300J, and KE600J, and carbon nanofibers prepared by the catalytic chemical vapor deposition of C2H4 over Ni-Cu catalysts were used as the carbon fillers. The electrical conductivity of carbon filler/PVdF composites were in the range of 0.65 to 13.5 S/cm depending the fillers' electrical conductivity ranging from 5.6 to 23.1 S/cm. Among the carbon fillers used, the KE600J carbon black showed the highest conductivity both in the composite and filler itself because of its high degree of graphitization due to the high-temperature thermal treatment and its high surface area due to the activation treatment.
4,000원
5.
2003.09
구독 인증기관 무료, 개인회원 유료
A copolymer 〈HSAs : EA/EMA/2-HEMA/AAEM) which is an acrylic resin containing 70% solid content was synthesized by the reaction of monomers, including ethyl acrylate, ethyl methacrylate, and 2-hydroxyethyl methacrylate with a functional monomer, such as acetoacetoxyethyl methacrylate, which may give improvements in cross-linking density and physical properties of films. The physical properties of prepared acrylic resins, HSA containing AAEM, are as follows : viscosity, 203~550cps ; Mn, 2590~2850 ; and conversion, 82~89%, respectively. It was found from the plotting of Tg versus viscosity and Tg versus molecular weight that viscosity increased with Tg while number averaged molecular weight decreased with increasing Tg.
4,000원
6.
2003.09
구독 인증기관 무료, 개인회원 유료
Synthesis gas is commercially produced by a steam reforming process. However, the process is highly endothermic and energy-consuming. Thus, this study was conducted to produce synthesis gas by the partial oxidation of methane to decrease the energy cost. Supported Ni catalysts were prepared by the impregnation method. To examine the activity of the catalysts, a differential fixed bed reactor was used, and the reaction was carried out at 750~850℃ and 1 atm. The fresh and used catalysts were characterized by XRD, XPS, TGA and AAS. The highest catalytic activity was obtained with the 13wt% Ni/MgO catalyst, with which methane conversion was 81%, and H2 and CO selectivities were 94% and 93%, respectively. 13wt% Ni/MgO catalyst showed the best MgNiO2 solid solution state, which can explain the highest catalytic activity of the 13wt% Ni/MgO catalyst.
4,000원
7.
2003.09
구독 인증기관 무료, 개인회원 유료
The high-solid coatings were prepared by blending the synthesized acrylic resin in the previous paper and hexamethylene diisocyanate-trimer and curing it at room temperature. The characterization of the films of the prepared coatings was performed. The impact resistance, 60℃ specular gloss, cross-hatch adhension, and heat resistance of the films proved to be good, and the pencil hardness and drying time proved to be slightly poor. Especially, there was a remarkable improvement in the heat resistance. This improvement may stem from the regular arrangement of ethyl groups introduced into the acrylic resin. From a viscoelastic measurement using a rigid-body pendulum, curing was accelerated with the Tg value. With the increase in Tg, log damp value was lowered and dynamic viscoelasic Tg of a cured film was increased.
4,000원
8.
2003.09
구독 인증기관 무료, 개인회원 유료
Poly(methyl methacrylate)/clay nanocomposite particles with particle size of 275~292 nm range were successfully prepared using emulsion polymerization. The content of montmorillonite based on the methyl methacrylate monomer was chosen as 30 wt.%. 2,2-azobis(isobuthylamidine hydrochloride) and n-dodecyltrimethylammonium chloride were used as an initiator and a surfactant in cationic emulsion system. Potassium persulfate and sodium lauryl sulfate were used as an initiator and a surfactant in anionic emulsion system. The evidence of intercalated /exfoliated structure of montmorillonite in the nanocomposite prepared in our experiment was confirmed by wide angle x-ray diffraction patterns of d001 plane. Thermal behavior of nanocomposite was traced using DSC and TGA. It was found that the nanocomposite particle prepared by cationic emulsion system showed intercalated structured. We also found that the nanocomposite particle obtained from anionic emulsion system resulted in the fully exfoliated structure.
4,000원
9.
2003.09
구독 인증기관 무료, 개인회원 유료
Biodiesel as methyl esters derived from vegetable oils has considerable advantages in terms of environmental protetion. In the present work, methyl esters were produced from soybean oil by lipase-catalyzed transesterification. To reduce inactivation of commercial immobilized lipases emulsified two-step process was developed using the stepwise addition of methanol with 4:1 molar ratio at 4h intervals. Also with immobilized lipase from Candida antarctica(Novozym 435) high conversion of 98.5 percent was possible at 45℃ of reaction temperature with 4:1 of methanol-to-oil molar ratio and 1%(v/v) methyl glucoside oleic polyester as an emulsifier in the presence of cosolvent.
4,000원
10.
2003.09
구독 인증기관 무료, 개인회원 유료
4,000원
11.
2003.09
구독 인증기관 무료, 개인회원 유료
IASL(iodo acetamide spin label) and MSL(maleimide spin label) disordered the orderly helix arrangement of myosin in the rest state of spin level. Especially the effect of IASL was great. The muscle was isometrically tetanized with three trains of 3ms pulses every 50ms between 5℃ with 25℃. Equatorial reflection change inferred that myosin head was moved to the vicinity of actin filament by spin level. The intensity change of 143a and 72a could offer information of the mass projection of population of myosin head along the filament axis. The slope of intensity profile of the mass projection of 143a and reflection of IASL is appeared and that of MSL is appeared sharply. The decrease of 215a reflection intensity the periodical character of 143a reflection by spin label. The raise of MSL actin reflection at 51a and 59a in the actin reflection change refers that the shifted myosin head binds a certain actin or changes an actin structure by spin label effect. Because iodo acetamide has a tendency to decease the actin reflection, actin dose not bind myosin head. From this result, we can conclude that IASL and MSL are spin labeled on SH of myosin head and disordered the helix arrangement of actin.
4,000원
