Naphthoquinone-1,2-diazide-5-sulfonyl [NDS]derivatives members of Quinone diazide compound that are utilizable as photoresist for printing plate were synthesized, and photoresist were prepared by mixing these derivatives with a matrix resin(PF, CF) at various weight ratios. Photosensitive characteristics of photoresist were studied by Gray scale method, and SEM to analyze if they can be used as photosensitive material in a printing plate. Experimental results showed using IR, UV, NDS derivatives were photoconverted and developer-soluble photoresist were produced. Photoresist in the mixing ratio of 1:4 of NDS[II] and CF resin gave rise to the highest dissolution rate. In addition, photoresist obtained at this condition resulted in the most superior sensitivity.
The organization of phospholipid monolayers and their monolayers mixed with fatty acid containing azobenzene on the water surface was investigated by means of the displacement current measurement method. The phase transition from the gaseous phase to the gaseous-fluid phase which accompanies the polar ordering of phospholipid molecules was detected in the range of immeasurably low surface pressure. The molecular area which gives the onset of the transition was determined for phospholipid monolayers. The Maxwell displacement current(MDC) pulses were generated across mixed monolayers due to the photoisomerization of fatty acid containing azobenzene by alternating irradiation of ultraviolet and visible light, because the condensation of pure azobenzene monolayers was loosened by the introduction of phospholipids into the monolayers. The displacement currents generated during light irradiation were also investgated in connection with monolayer compression cycles. It was found that the maximum of MDC appeared at the molecular area just before the initial rise of surface pressure in compression cycles.
Separation of EPA and DHA from fish oil fatty acid ethyl ester (FAFE) by urea adductive crystallization method was carried out in the supercritical carbon dioxide (SC CO2) as a solvent. Our results showed that SC CO2 is a good candidate as a solvent in the urea adductive crystallization to separate FAFE by the number of unsaturated bonds. Compared to the separation process using methanol. SC CO2 yielded better performance in the overall selectivity of EPA and DHA. The effect of process variables on separation of EPA and DHA was discussed in detailed. A hybrid technology of SC CO2 fractionation and urea adductive crystallization with SC CO2 was conformed as a viable process to separate and concentrate EPA and DHA from fish oil.
It was tested the possibility that EPA and DHA could be separated from fish oil fatty acid ethyl ester(FAEE) in the supercritical carbon dioxide rectification method. Experiments were carried out in the 1800mm tall and temperature gradient packed rectification column at the pressure of 100bar and carbon dioxide flow rate of 52.43NL/min. Experimental results showed that this method was useful to separate the FAEE by the relative volatility of the components. The maximum attainable concentration of EPA, DHA and both of them in product were 41%, 43% and 57% respectively in this rectification column using raw fish oil feed.
The symmetric naphthothiazolo carbocyanine is of industrial importance as green-sensitizing dye in the spectral sensitization of emulsion microcrystals in negative film-making. In this study, green-sensitizing dye was prepared by the reaction of 2-methyl-3-sulfopropyl-5-phenyl-benzoxazolium(inner salt) with triethyl orthoacetate in the presence of triethylamine. The product was identified by using various analytical tools such as Elemental analyzer, IR spectrophotometer, UV-Vis spectrophotometer, 1H-NMR spectrometer, TGA and DSC. The maximum absorption peak in methanol solvent was 502nm. Therefore, it was concluded that benzoxazolo carbocyanine dye can be used as green-sensitizing dye for the spectral sensitization of photographic emulsion.
The symmetric naphthothiazolo carbocyanine is of industrial importance as red-sensitizing dye in the spectral sensitization of emulsion microcrystals in negative film-making. The stability on the solvents of naphthothiazolo carbocyanine dye was measured by UV-Vis spectrophotometer, and then all of solvents were stabilized sensitizer. The maximum absorption peak range in various solvents was 600nm~612nm. But it was identified that only methanol can be used to photographic emulsion.
Ultra-thin films of poly[2-[4-(9-(10-phenyl)anthracenyl)phenoxy)hexyloxy]]-1,4-phenylenevinyleylene(PAHPV) were prepare-d on the hydrophilic ITO substrate by Langmuir-Blodgett(LB) technique. λmax in the photoluminescence spectrum of these films was 458nm at the excitation wavelength of 365nm before thermal treatment, which comes from diphenylanthracene side chain of PAHPV. It was also confirmed with UV-Vis spectrometer that ultra-thin LB films of PAHPV precursor polymer were prepared well. After thermal treatment for conjugation of PAHPV precursor polymer, λmax in the photoluminescence spectrum of these films changed to 365nm, which means that the conjugation of these PAHPV films was completed.
Tris(8-hydroxyquinoline)-aluminum complex(AlQ3) having greenish luminescent characteristics was synthesized and it was confirmed with UV-Vis absorption spectroscopy, elemental analysis, and FT-IR spectroscopy that AlQ3 was successfully synthesized. Thin films of AlQ3 having multilayer structure were prepared by spin coating method and vacuum evaporation technique. Photopluminescent characteristics of these films were investigated by Luminescence spectroscopy and Current-Voltage(I-V) characteristics of these films were also investigated.
서로 다른 씨클로펜타디엔 유도체가 π-결합된 최초의 비스무스 화합물인 η5-C5(CH3)5Bi(η5-C5H5)2이 디펜타메틸씨클로펜타디에닐 비스무스디메틸아미드 Cp*2BiNMe2[Cp*=C5(CH3)5]와 씨클로펜타디에닐 모노머와의 반응으로 합성되었다. 반응조건은 에테르 용매하에 -78℃ 반응온도 조건하에서 얻어졌다. 합성된 반응물을 노르말 헥산 용매에서 재결정시킨 결과, 검은색 결정이 60% 수율로 얻어졌다. 그리고 재결정시킨 반응물을 190K에서 X-선 단결정 구조 분석 방법에 의해 그 구조를 밝혔다. 그 결과 결정계의 격자계는 I2/a, a=1756.00 picometer, b=906.00 picometer, c=2211.00 picometer, β=104.04, Z=8로 확인되었다. 여기서 a, b, c는 결정?Ю? 상수이고, β는 결정격자 상수인 b와 c간의 각도이며, Z는 단위 결정 격자당 분자의 갯수이다.
Isothiazoline derivatives is widely used to food, medical drug and industrial goods, cosmetics etcs, and it makes to restrain and to sterilize a breeding of microbe as a preservative and a sterilizing agent. It differs with the raw material of paraoxybenzoic acid derivatives or imidazolydinyl urea to be in use at present, on the efficacy and effect, and has various characteristics. This synthesis makes 3,3'-dithiodipropionic chloride to add a thionyl chloride in 3,3'-dithiodipropionic acid, and 3,3'-dithiodipropionic methyl amide makes to synthesize in a reflux reaction the mono methyl amine to 3,3'-dithiodipropionic chloride. And last synthesis becomes to make chlorination-cyclization molecule doing a reflux reaction in the temperature of 90~100℃ to mix excessively thionyl chloride and ethylene dichloride to 3,3'-dithiodipropionic methyl amide. The last synthesis material has got in the mixture of 5-chloro-2-methyl-4-isothiazoline-3-one and 2-methyl-4-isothiazoline-3-one, and it is so-called isothiazoline derivatives. The purification of isothiazoline derivatives makes to fuse in ethyl acetate, and makes to decolorize and to deodorize in recrystallization. This experiment has been in synthesis and purification of isothiazoline derivatives, and has tried to measure on the antisepsis and sterilization function of microbe according to pH or content change.
Metachromatic properties of admixture of methylene blue(MB) and thionine in aqueous solution has been studied by fluorescence spectroscopy. In spite of nonfluorescence character has been MB itself, mixing MB to monomeric concentration of thionine, new coaggregation band has been formed in shorter wave length than fluorescence of thionine because of MB was redistributed to thionine aggregate. It suggested that coaggregate of MB and thionine were more tightly formed than the each dye aggregate.
The field of printing use to pressurization ink using screen gassamer that is called screen printing. Existing cleaning solvent using screen printing are the organic solvents including aromatic compounds carried with poisonous and stench. Besides, cleaning method of current screen printing are for the most part mixed cleaning method of dipping and polish. Using 1,1,1-TCE, CFC-113 alternative system cleaning solvent be substituted for existing cleaning solvent against screen printing ink measured the cleaning efficiency according to gravimetric analysis method and property change of gassamer according to Image Analyzer. Also, Cleaning process system carry with excellent cleaning efficiency studied which was proposed new cleaning process including ultrasonic and vibration cleaning process be substituted for existing mixed cleaning method of dipping and polish.