간행물
한국응용과학기술학회지 KCI 등재 The Korean Society of Applied Science and Technology
- 발행기관 한국응용과학기술학회(구 한국유화학회)
- 자료유형 학술지
- 간기 격월간
- ISSN 1225-9098 (Print)2288-1069 (Online)
- 수록기간 1984 ~ 2024
- 주제분류 공학 > 화학공학 공학 분류의 다른 간행물
- 십진분류KDC 575DDC 665
권호리스트/논문검색
Vol.23 No.2 (2006년 6월) 10건
1.
2006.06
구독 인증기관 무료, 개인회원 유료
In order to obtain the maximum flame retardancy as well as the minimum deterioration of physical properties of PU flame-retardant coatings, chlorine and phosphorus functional groups were introduced into the pre-polymer of modified polyesters. In the first step, the tetramethylene bis(orthophosphate) (TBOP) and neohexanediol dichloroacetate (DCA-adduct) intermediates were synthesized. In the second step, 1,4-butanediol and adipic acid monomers were polymerized with the two kinds of intermediates to obtain copolymers. The modified polyesters containing chlorine and phosphorus (ATBA-10C, -20C, and -30C) were synthesized by adjusting that the content of phosphorus compound was fixed as 2wt% and the contents of chlorine compound (dichloroacetic acid) were varied as 10, 20, and 30wt%. Average molecular weight and polydispersity index of the preparation of ATBAs were decreased with increasing DCA content because of the increase in hydroxyl group that retards reaction.
4,200원
2.
2006.06
구독 인증기관 무료, 개인회원 유료
The high-solid coatings were prepared by blending the synthesized acrylic resin in the previous paper, and hexamethylene diisocyanate-trimer and curing it at room temperature. The characterization of the films of the prepared coatings was performed. The 60˚ specular gloss, impact resistance, cross-hatch adhesion, and heat resistance of the films proved to be good, and the pencil hardness, drying time, and pot-life proved to be slightly poor. From a viscoelastic measurement using a rigid-body pendulum, curing was accelerated with the Tg value.
4,000원
3.
2006.06
구독 인증기관 무료, 개인회원 유료
From the result of pharmacetical characteristics and analysis of Green-tea extract, it could obtain some conclusions as follows. The extract experiment of Green-tea appeared about 10%-extraction ratio as semi-solid state, and after dried in freezing from Green-tea extract of semi-solid state, it obtained about 65% Green-tea extract as solid state. In the results on antimicrobial experiment of Green-tea extract, number of S-typhimurium and fungus in microbe decreased more and more according to the time passage. This phenomenon could show that Green-tea extract keeps antimicrobial effect. In the results on antioxidation experiment of Green-tea extract, DPPH scavenging activity of free radical showed that Green-tea extract appears more remarkable reduction ability than reference samples. This phenomenon means that antioxidation of Green-tea extract appears higher than Vitamin-C and BHA sample. In the results on intrument analysis, the fatty and aromatic components of aniline, acetaldehyde, acetic acid, trichloroethylene, caffeine etcs from Green-tea extract was detected with GC/MS analysis and inorganic components of Ca, Mg, Cu, Mo, Sb, Ti etcs from Green-tea extract was detected with ICP/OES analysis.
4,000원
4.
2006.06
구독 인증기관 무료, 개인회원 유료
Benzoxazolo carbocyanine compounds were synthesized by condensation of a suitable ortho-ester with an appropriately substituted 2-methylbenzoxazole in the presence of triethylamine. This compounds used as green sensitizing dyes in photographic emulsions. The compounds are characterized by fast atom bombardment mass spectrometry. The values(m/z) of structurally significant ions observed in FAB spectra. It was showed tentative fragmentation pattern in FAB spectroscopy of HN(C2H5)3 cations in glycerol/trifluoroacetic acid matrix.
4,000원
5.
2006.06
구독 인증기관 무료, 개인회원 유료
Theoretical total nitrogen removal efficiency and reactor volume ratio in oxic-anoxic-oxic system can be found by influent water quality in this study. The influent water quality items for calculation were ammonia, nitrite, nitrate, alkalinity, and COD which can affect nitrification and denitrification reaction. Total nitrogen removal efficiency depends on influent allocation ratio. The total nitrogen removal follows the equation of 1/(1+b). Optimal reactor volume ratio for maximum TN removal efficiency was expressed by those influent water quality and nitrification/denitrification rate constants. It was possible to expect optimal reactor volume ratio by the calculation with the standard deviation of ±14.2.
4,000원
6.
2006.06
구독 인증기관 무료, 개인회원 유료
We investigated the electrochemical properties for Langmuir-Blodgett (LB) films mixed with fatty acid (8A5H) and phospholipid (DLPE, DMPC, and DPPA). LB films of 8A5H monolayer and 8A5H-phospholipid mixture were deposited using the Langmuir-Blodgett method on the indium tin oxide(ITO) glass. The electrochemical properties measured using cyclic voltammetry with three-electrode system, an Ag/AgCl reference electrode, a platinum wire counter electrode and LB film-coated ITO working electrode at various concentrations(0.1, 0.5, and 1.0 mol/L) of NaClO4 solution. A measuring range was reduced from initial potential to -1350 mV, continuously oxidized to 1650 mV and measured to the initial point. The scan rate was 50, 100, 150 and 200 mV/s, respectively. As a result, LB films of fatty acid and phospholipid (8A5H/DLPE and DPPA) appeared irreversible process were caused by only the reduction current from the cyclic voltammogram and LB film of 8A5H-DMPC mixture was found to be caused by a reversible oxidation-reduction process.
4,000원
7.
2006.06
구독 인증기관 무료, 개인회원 유료
The accidents occurred by unstable material which is easily exploded or burnt up were caused by heat and collision under the condition of relatively low temperature without oxygen, have been reported frequently. However, the amount of the unstable material is getting higher by development of fine ceramic research area even though its dangerous characteristic is disregarded. This research studied a heat stability and measured boiling point of various carpet material. Carpet has been used in home as well as general indoor usage. Now a day, carpet material which is hardly burnt has been on commercial, but its detailed unstable conditions is not mentioned. This research reports the measurement of the initial temperature of generation heat and heat-radiation change on differential scanning calorimeter (DSC). The DSC data of nylon bulked continuous filament (N-BCF) yam 100%, nylon (NY), poly propylene (PP), and a new material named polytrimethylene terephthalate (PTT) are studied and researched about the effect of them using TGA, furnace, and direct-burning experiment.
4,000원
8.
2006.06
구독 인증기관 무료, 개인회원 유료
The photocatalytic degradation of methylene blue(MB) was investigated using TiO2 as photocatalyst and UV radiation. TiO2 supported with activated carbon(AC) was prepared by SOL-GEL method and depended on several parameters such as the mass ratio of TiO2/AC, pH and experimental time. The presence of the anatase and rutile crystal phase was determined by XRD analyses of the prepared TiO2. The degradation of MB with TiO2/AC was about 20% higher than that of AC alone. A variation of photodegradation was negligible under UV radiation conditions ( ≥ 40W). It was experimentally showed that the photodegradation rate was increased with increasing the amount of photocatalyst. The optimal catalyst was prepared by impregmation of 5wt%-TiO2 with AC and was calcined at 300℃, and showed about 99% removal efficiency for 3hrs.
4,000원
9.
2006.06
구독 인증기관 무료, 개인회원 유료
The conductances of trimethyltetradecylammonium bromide (TTAB) plus triphenyltetradecyl phosphonium bromide (TTPB) and TTAB plus trimethylhexadecylammonium bromide (HTAB) over the entire mole fraction range of TTAB were measured in water and in cyclodextrin plus water mixtures at fixed 4 and 8 mM of cyclodextrin at 30℃. The conductivity plot for both binary mixtures shows a single break from which the mixed critical micelle concentration and degree of micelle ionization were computed. From the slope of the conductivity curve, the equivalent ionic conductivities of the monomeric, associated, and the micelle states were calculated and discussed with respect to the surfactant-cyclodextrin complexation in the whole mole fraction range of both surfactant binary mixtures. The association constant K between the respective monomeric surfactant and cyclodextrin cavity of fixed 4 mM cyclodextrin was computed by considering 1:1 association from the surface tension measurement. A comparison among the K values for HTAB-cyclodetrin, TTAB-cyclodextrin, and TTPB-cyclodextrin shows that the former complexation is significantly stronger in comparison to the other ones due to the longer hydrophobic tail.
4,000원
10.
2006.06
구독 인증기관 무료, 개인회원 유료
Acrylic adhesives for automobiles protection were prepared by emulsion polymerization. Monomers used were n-butyl acrylate(BA), acrylonitrile (AN), butyl methacrylate(BMA), glycidyl methacrylate(GMA), and acrylic acid (AA). Emulsifiers used were sodium lauryl sulfate and polyoxyethylene lauryl ether, which are an anionic emulsifier and a nonionic emulsifier respectively. Potassium persulfate was used as an initiator and polyvinyl alcohol was used as a stabilizer. Emulsion polymerization was carried out in a semi-batch reactor at 70℃ and agitation speed was kept at 200 rpm. Water resistance, heat resistance, acid resistance, alkali resistance and smoke resistance were examined. As a result, when each 0.03 mole of GMA and AA was introduced, the adhesion properties and various above mentioned resistances of the prepared adhesives were satisfied the standard for automobiles.
4,000원
