ATP luminescence measurements (using Relative Light Units, RLU) has been used to assess the levels of bacterial contamination on the surfaces of various materials. However, not much is known about their suitability in assessing bacterial contamination on paper surfaces. This study was conducted to evaluate the feasibility of using ATP luminometers in measuring levels of bacteria contamination on paper surfaces. The three ATP luminometers studied were Clean-Q, smart PD-30, and 3M™ Clean-Trace™ LM1 manufactured by different companies. There were some differences in RLU results among the three ATP luminometers when they were tested with different concentrations of Micrococcus luteus cell suspension. 106 - 107 cells were required in order to effectively detect Bacillus subtilis, Escherichia coli, and Micrococcus luteus on the surfaces of A4 printing sheets (100 cm2) when using the three ATP luminometers. The sizes and physical properties of surface areas varied slightly among the swabs used for the three ATP luminometers. Concentration-specific measurements (RLU) of M. luteus taken from the surfaces of six kinds of paper (fine print paper, medium print paper, ground paper, newsprint paper, practice paper, tracing paper) were possible using the smart PD-30 and LM1 ATP luminometers. ATP detection values of M. luteus varied among the six types of paper. The highest ATP detection values were found on the surfaces of tracing paper. If the RLU value is recorded at the level of 1000, this could indicate a very high bacterial contamination level of 105 to 106 CFU/4 cm2.

The air dilution olfactory method to measure complex odors needs to store and carry odor samples from the field sampling until the analysis in laboratories. Until the analysis of sample in the laboratory, odor dilution factor (odor sensitivity) in the sample bag may decrease over time depending on the characteristics of each odor substances. This is one of the limitation for the air dilution olfactory method. Thus, the air dilution device enable to measure without loss in complex odors of samples. Recently, many studies on the performance test of on-site air dilution devices, i.e., field olfactometer, has been conducted to figure out the feasibility of the field olfactometers. In this study, seven odor samples were collected from five odor emission source sites. And comparative analysis with the air dilution olfactory method was carried out to assess the field applicability of the olfactometer. As results, the performance of the field olfactometer used in this study is regared as the affordable method. The dilution factors from between two methods showed the similar values, indicating low values of standard deviations. In order to ensure the accuracy and precision of measurement data using the field olfactometer, methodology minimized variables (that may affect measurement) needs to establish.

Ethyl formate (EF) is a naturally occurring insecticidal compound and is used to control pests introduced from abroad, in quarantine, by a fumigation method. In particular, it is mainly used as a substitute for methyl bromide and is less toxic to humans and less harmful to plants. This study aimed to investigate the possible acute toxicity of EF to useful organisms, and how to reduce phytotoxicity in watermelon, zucchini, and oriental melon. After fumigation with EF for 2 h, the LC50 values for earthworms, honey bees, and silkworms were 39.9, 7.09, and 17.9 g m-3, respectively. The degree of susceptibility to EF was in the order of earthworms, silkworms, and honey bees based on the LC50 value, and EF fumigation induced stronger acute toxicity to honey bees. Phytotoxicity was observed in watermelon leaves treated with a concentration of 7.5 g m-3 EF, and when treated with a concentration of 10.0 g m-3, it was confirmed that the edges of watermelon leaves were charred and seemed to be damaged by acids. Zucchini and melon, and other cucurbits, showed strong damage to the leaves when treated with a concentration of 10 g m-3, and sodium silicate, at concentrations of 10% and 20%, was used to reduce phytotoxicity. Therefore, acute toxicity towards nontarget organisms and phytotoxicity during the fumigation of EF should be reduced for efficient agricultural pest control.

A new brown variety of Flammulina velutipes, referred to as ‘Asakgold,’ was bred by crossing two monokaryons isolated from the “Geumhyang2ho” and “Garlmoe” varieties. The pileus color of the new variety is light brown and its shape is hemispherical. During bottle cultivation, the period necessary for mycelial growth was 40 days, 9 days for primordia formation and 15 days for fruiting body growth. The total cultivation period was 64 days, which was similar to that of the control variety “Yeoreumhyang1ho.” The pileus of the new variety was similar and the stipe was thinner and longer than that of the control. The number of valid stipes per bottle was 495, which was 37 % higher than that of the control (362), and the yield was 214 g, 16 % higher than that of the control (185 g). The -glucan content was 28.69 %, which was observed to be 1.6 times more than that of the control.

The effects of punching treatment on mycelial culture and fruiting body productivity were investigated in a new Lentinula edodes cultivar, “Jadam”, in sawdust medium for the stable production of oak mushroom. As the punching volume and number increased, the weight loss rate and color difference increased and the L value decreased. After spawn inoculation, the sawdust medium temperature and CO2 concentration reached their highest values at 33 and 19 days of incubation, respectively. The O2 concentration showed the lowest value on the 14th day of incubation, which was the opposite pattern to the CO2 concentration. As the punching volume and the number increased, the medium temperature and O2 concentration increased, and the CO2 concentration decreased. Higher punching volumes and numbers resulted in higher temperatures and lower CO2 concentrations. The best fruiting body yield was 5 × 70 mm - 30 (punching diameter × depth - number), and the total yield after three cycles was 644.7 g.

A new spore-less cultivar Lentinula edodes ‘Daedam’ was bred from monokaryotic strains of ‘LE15401-24’ and ‘LE192118-10’. The optimum temperature for mycelial growth of ‘Daedam’ on potato dextrose agar was 22~25oC. Total cultivation period of the new cultivar, from inoculation to its first harvest, was 134 days, similar to that of the control cultivar ‘Hwadam’. Total yield of ‘Daedam’ was 222g per 3kg substrate, and was lower than that of control cultivar(266.0g). The fruiting body of ‘Daedam’ had a thick and small pileus and a longer stem compare to control cultivar. As a result of a analyzing the productivity of ‘Daedam’ on the different substrate types, the biological efficiency was 26.7% in the 1.2kg cylindrical substrate(CS), which was higher than that of the 3kg rod-type substrate(RS). 'Daedam' had a similar yield compared to 'Hanacham' in first fruiting body production, but the cultivation period was 40 days shorter. Therefore, 'Daedam' can only harvest fruiting bodies once, it is thought that it can be used as spore-less oak mushroom cultivar for short-term cultivation instead of 'Hanacham' in mushroom farms.