간행물
Journal of Korean Navigation and Port Reserch KCI 등재 한국항해항만학회지
- 발행기관 한국항해항만학회
- 자료유형 학술지
- 간기 격월간
- ISSN 1598-5725 (Print)2093-8470 (Online)
- 수록기간 1977 ~ 2020
- 주제분류 농수해양 > 해상운송학 농수해양 분류의 다른 간행물
- 십진분류KDC 559DDC 629
권호리스트/논문검색
Vol.5 No.2 (1981년 12월) 6건
1.
1981.12
서비스 종료(열람 제한)
A doppler log is the typical device which can measure the ship's speed over the ground directly, by means of doppler effect of the underwater ultrasonic wave, which involves the error due to the sea bottom inclination, the trim and the incorrect transducer installation etc. The present doppler log adopts a single transducer, faced in the direction of themain beam, and therefore it is unable to correct the beam direction to eliminate the above mentioned error. Moreover, the frequencyis also limitted in a comparatively high range for getting a sharp beam with single transducer, and the speed over the ground can not be detectable at the deep sea, for an instance, over 200 meters. This paper describes a theoretical consideration for the doppler log error and an analysis by a computer on the observed speed data by a full size model ship. The result is verified that the most of doppler log error is caused by the ultrasonic beam angle of transducer. To eliminate the doppler log error due to the incorrect transducer installation and also to sharpen the beam for lower frequency range to expand measurable sea depth, this paper proposes a method of controlling the directivity adopting a linear transducer array and of controlling the directivity by the control of exciting current, and investigates by the computer simulation and make experiment with magnetostrictive ferrite transducer of 28, 50 and 75KHz. The experimental results are shown well coincide with the measured ones, and they are revealed that in case where the transducer interval is greater than 1 wavelength, the effective control of the beam direction is hardly performed with keeping adequate beam width and side lobe level. It is concluded that 6-elements array with inter element space of a half wavelength can make comparatively sharp beam and low side lobe level. The results obtained here will contribute very much to the improvement of the performance of doppler log.
2.
1981.12
서비스 종료(열람 제한)
Many new radar techniques have appeared on the electronic scene in recent years, such as a variety of automatic computer processing. However, even with the advent of these sophisticated radar techniques, an old problem continues to plague all radars: the problem of transmission line losses. With the higher performance required today, the Waveguide testing and trouble-shooting techniques remain essentially unchanged in principle. This paper dealt with the rf pulse "Time-domain Reflectometry" to inspect radar wave-guide system and compared with the conventional methods. During the investigation, it was verified that the pulsed TDR for wave-guide is superior to the conventional methods; 1. Disassembling is not needed to locate the discontinity points and measure the reflections of trobled points. 2. The results of the data are more precise. 3. The condition of individual component is able to the photographed and recorded permanently. 4. Since rf pulse TDR is based on the well-known basic radar principle, such a test set requires the minimum of training to operate. With the level of transmission line problems, the prospect of increasing complexity of equipment, and no relief in sight, the benifits must be emphasizied to adopt such a testing procedure.procedure.
3.
1981.12
서비스 종료(열람 제한)
One of the main purposes of the marine gyrocompass follow-up system is to preserve the sensitive part from the wandering error due to the frictional or torsional torque around the vertical axis. This error can be diminished through the rapid follow-up action, which minimizes the relative azimuthal angular displacement between the sensitive and follow-up parts and shortens the duration of the same displacement. But an excessive rapidity of the follow-up action would result in a sustained oscillation to the system. Therefore, to design a new type of the follow-up system, the theoretical annlysis of the problems concerned should be studied systematically by introducing the control theory. This paper suggest a concrete procedure for the optimal adjustment of the gyrocompass follow-up system, utilizing the mathematic model and the stability informations formerly investiaged by the author. For theoptimal determination of the adjustable paramfter K, the performance index(P.I.), ITSE(Intergral of the Time multiplied by the Squared Error) is proposed, namely, P.I. = ʃ0∞ t · e2(t)dt where t is time and e(t) means control error. Then, the optimal parameter minimizing the performance index is calculated by means of Parseval's theorem and numerical computation, and the validity of the obtained optimal value of the parameter Ka is examined and confirmed through the simulations and experiments. By using, the proposed method, the optimal adjustment can be performed deterministically. But, this can not be expected in the conventional frequency domain analysis. While the Mps of the original system vary to the extent of from 0.98 to 46.27, Mp of the optimal system is evaluated as 1.1 which satisfies the generally accepted frequency domain specification.
4.
1981.12
서비스 종료(열람 제한)
Many studies have been done in the field of fuzzy logic theory, but it's application is not so much, and particularly, there isn't any application to the ship's steering system, until now. This paper is to survey the effect of application of fuzzy logic control to the ship's steering system. The controller is made up of a set of Linguistic Control Rules which are conditional linguistic statements connecting the inputs and the output, and take the inputs derived from the errors, that is, deviation angle and it's angular velocity. These two variables together give information about the state of the steering system, and the Linguistic Control Rules are implemented on the digital computer. The characteristics of this system were investigated through the computer simulation and satisfactory results compared with that of the conventional PD controller were obtained.
5.
1981.12
서비스 종료(열람 제한)
Presently, there are some means of voyage estimations such as Hire base, Charter base, and Anticpated income and expenditure statement of voyage. The former two are the means of estimation for profit of a ship's voyage per a deadweight tonnage adn a month, and it is well used in the case of chartered ships. But it is somewhat meaningless for the shpowner who runs his ships for himself. The latter means for estimation is mainly used in western shipping, and do not set forth simpler way of comparing profit with another voyage or with another ship's employing in other route. And this paper has yielded an index of ship's voyage profit evaluation by building a model of ship's voyage evaluation formula, and the index may be used in evaluation of the new investigation of shipping as well as setting out a shiop in a voyage. The model has yielded a break even curve which may be used for deciding the amount of demurrage and the period of ship's port time for a specific voyage contraction.
6.
1981.12
서비스 종료(열람 제한)
As far as ship's cargo handling devicesareconcerned, the derrick system has been used comprehensively in the marine. Even though there are several new devices for ship's cargo gear, such as gantry crane, jib crane adn self unloader, the derrick system, with its improved rigging method, still retains its utmost reputations among ship's owners. Therefore the method of calculating the system's militating stresses in the course of cargo operation needs to be more convenient and analytical. Here the author attempts to introduce the calculating method of stresses by means of vector analysis. The calculating method is able to analyze the stresses acting in every part of the cargo gear systems, such as union purchase, slewing or its modified system.
