간행물
Journal of Korean Navigation and Port Reserch KCI 등재 한국항해항만학회지
- 발행기관 한국항해항만학회
- 자료유형 학술지
- 간기 격월간
- ISSN 1598-5725 (Print)2093-8470 (Online)
- 수록기간 1977 ~ 2020
- 주제분류 농수해양 > 해상운송학 농수해양 분류의 다른 간행물
- 십진분류KDC 559DDC 629
권호리스트/논문검색
Vol.33 No.9 (2009년 12월) 8건
1.
2009.12
서비스 종료(열람 제한)
In this paper, a 3m-class free running model ship will be introduced with its manoeuvring performance experiments. The results of turning circle test and zig-zag test will be explained. The developed system are equipped with GPS, main control computer, wireless LAN, IMU (Inertial Measurement Unit), self-propulsion propeller and driving rudder. Its motion can be controlled by RC (Radio Control) and wireless LAN from land based center. Automatic navigation is also available by pre-programmed algorithm. The trajectory of navigation can be acquired by GPS and it provides us with important data for ship's motion control experiments. The results of manoeuvring performance experiment have shown that the developed free running model ship can be used to verify the test of turning circle and zig-zag. For next step, other experimental researches such as ship collision avoidance system and automatic berthing can be considered in the future.
2.
2009.12
서비스 종료(열람 제한)
The traffic of tug/barges which are carrying construction materials, large plants for harbor development, or offshore structures has recently increased in the coast of Korea. The west and south coast of Korea are always congested due to a lot of islands and traffic concentration. Specially tug/barges have higher probability of marine accidents due to their bad maneuverability than others. Considering the operational circumstance and maneuverability, this study was to develop a wide-area monitoring and control system for tug/barges in the coastal area of Korea. The system was made in the form of three program modules i.e. navigation analysis program module, monitoring and control program module, database module. And seven functions were programmed to monitor and control the tug/barges efficiently. These are ship information search, tug/barge information and track management, designated area and safe navigation zone management, fairway management, accident data management, warning of danger, safety information management.
3.
2009.12
서비스 종료(열람 제한)
Road and maritime transport which connecting main cities in the world is already fully saturated, and the loss cost caused by recent high oil prices is getting bigger. Transportation by inland waterway is rising as an alternative method of them. Concerning this, the GI Waterway is on construction to connect the Yellow sea and Seoul. Nevertheless, there are no existing aids to navigation around the area and no studies have been carried out for them. As the construction progresses, installation of proper aids to navigation should be considered and profound studies need to be carried out. This study focused on introduction of the cases and the systems of other countries inland waterway aids to navigation and suggested a suitable navigation aids system along the inland waterways in Korea and a way of installation for that system.
4.
2009.12
서비스 종료(열람 제한)
The objective of this paper is to make clear the difference of maneuvering characteristics of a VLCC in standstill from those of her in running. The authors made mathematic models to calculate maneuvering motions of a VLCC in standstill using various ahead engine with full rudder angle and calculated their motions in each case and compared the calculated values with those of the same vessel running in sea trial tests. The difference of motions between them is great. For example, a VLCC in standstill can achieve a great alteration of heading over 90 degrees within the distance of 0.2L advance while she advances 3.0L for 90 degrees turning in full running sea trial turning test. Therefore whenever a VLCC in standstill meets a vessel approaching in collision course situation in near distance, it is better and recommendable that she should use her ahead engine with full rudder to avoid collision. So "maneuvering trial tests in standstill conditions" should be added to the content of sea trial tests when a newly built VLCC commence to take sea trials, that has not been included until now.
5.
2009.12
서비스 종료(열람 제한)
Vessels stability problems need to resolve the nonlinear mathematical models of rolling motion. For nonlinear systems subjected to random excitations, there are very few special cases can obtain the exact solutions. In this paper, the specific differential equations of rolling motion for intact ship considering the restoring and damping moment have researched firstly. Then the partial stochastic linearization method is applied to study the response statistics of nonlinear ship rolling motion in beam seas. The ship rolling nonlinear stochastic differential equation is then solved approximately by keeping the equivalent damping coefficient as a parameter and nonlinear response of the ship is determined in the frequency domain by a linear analysis method finally.
6.
2009.12
서비스 종료(열람 제한)
The optimum design of power yacht belongs to the nonlinear constrained optimization problems. The determination of scantlings for the bow structure is a very important issue with in the whole structural design process. The derived design results are obtained by the use of real-coded micro-genetic algorithm including evaluation from Lloyd's Register small craft guideline, so that the nominal limiting stress requirement can be satisfied. In this study, the minimum volume design of bow structure on the power yacht was carried out based on the finite element analysis. The target model for optimum design and local structural analysis is the bow structure of a power yacht. The volume of bow structure and the main dimensions of structural members are chosen as an objective function and design variable, respectively. During optimization procedure, finite element analysis was performed to determine the constraint parameters at each iteration step of the optimization loop. optimization results were compared with a pre-existing design and it was possible to reduce approximately 19 percents of the total steel volume of bow structure from the previous design for the power yacht.
7.
2009.12
서비스 종료(열람 제한)
In this study, a series of laboratory experiments were carried out to investigate the weak reflection of regular and random water waves over a train of protruded permeable shore structures. A cylindrical slit type breakwater and the alternatives are employed and compared for reflecting and transmitting capabilities of incident waves including wave forces. A series of random waves were generated by using the Bretschneider-Mitsuyasu frequency and directional spectrum. Measured spectrum of irregular waves without breakwaters is verified by comparing with those of the input waves generated. Weak reflection is occurred at the breakwater center of the peak frequency. If the row of breakwaters is fixed at three layers and the relative height of breakwater is fixed at 0.6, around 45% of incident wave energy is reflected to offshore. It is also found that the transmission of directional random waves increases as the maximum frequency parameter increases. A very good agreement is observed. Reflection coefficients of permeable submerged breakwaters are less than those of impermeable breakwaters. The upside-down L shape is recommended for a small fishery harbor mooring in terms of reflecting capability and of practical application. The final design was applied to the wharf of a small beach of Seolly, near Namhae at the southeast coast of Korea.
8.
2009.12
서비스 종료(열람 제한)
The aim of this study draws out the Green Index of a Seaport (GIS) that is comprehensive and coordinated approach to diminish the negative impacts of port operations using a Factor Analysis (FA) which can evaluate the level of cleanness of seaport. For this purpose, the questionnaires were sent to the experts and port stake holders, and received 75 out of 100. In this survey, Cronbach's alpha has the numerical value 0.76. Thus it means that this survey has internal consistency reliability. Overall, 15 components were selected from the literature review and five factors were extracted by factor analysis.
