간행물
Journal of Korean Navigation and Port Reserch KCI 등재 한국항해항만학회지
- 발행기관 한국항해항만학회
- 자료유형 학술지
- 간기 격월간
- ISSN 1598-5725 (Print)2093-8470 (Online)
- 수록기간 1977 ~ 2020
- 주제분류 농수해양 > 해상운송학 농수해양 분류의 다른 간행물
- 십진분류KDC 559DDC 629
권호리스트/논문검색
Vol.14 No.2 (1990년 6월) 4건
1.
1990.06
서비스 종료(열람 제한)
The Radio Navigation System(R. N. S.) has been progressed consistantly with the development of electric-electronic engineering techniques since the R. D. E had been developed in 1910. The R. N. S. mostly depends on either Hyperbolic Navigation System(H. N. S.) or Spherical Navigation System(S. N. S.) in the ocean, and on Rectangular Navigation System (R. N. S.) in the air near the airport or an a combinations of the above systems in both area. Another effective R. N. S may be the Ellipse-Hyperbola Navigation System(E-H N. S.), which is proposed and named such in this paper. The equations calculating GDOP are derived and the GDOP values are calculated in the case of H. N. S., S. N. S, and E-H. N. S., respectively, for the specified case that four transmitting stations are arranged on the apex of a square, Then the GDOP diagrams of above navigation systems are presented for qualitative comparison in this paper. To measure the distances from the receiver to the stations in S. N. S., and/or the sum of distances to two stations in E-H N. S., the time synchronization between the transmitter clocks and the receiver clock is a major premise. The author has proposed the algorithm for getting this synchronmization utilizing the by S. N. S. or E-H N. S while GDOPs of those are relatively good. Even though clock synchronization error is a voidable due to the fix error used, the simulated results shows that the position accuracy of S. N. S. and E-H N. S. by the proposed method is far upgraded compared with that determined by H. N. S. directly, as far as the outer region of transmitter arrangement is concerned.
2.
1990.06
서비스 종료(열람 제한)
Recently, there is a tendency to design the large full ships with lower-powered engine as the means for energy saving in ship's navigation at seas. Such a lower-powered ship is anticipated to show the different propulsive performance in rough seas, because the fluctuation of main engine load of lower powered ship is relatively large as compared with higher-powered ship is relatively large as compared with higher-powered ship. The fluctuation of propeller load is nonlinear at racing condition in waves. It is due to the variation of inflow velocity into propeller, the propeller immersion and the characteristics of engine governor. In this paper, the theoretical calculation of the nominal speed loss and the numerical simulation for the nonlinear load fluctuation of a model ship in rough seas are carried out. From the results of calculation, the following are discussed. (1) The ratio of nominal speed loss to the speed in still water. (2) The manoeuvring ability of ship and the operational ability of main engine in a seaway. (3) A method of the evaluation for the fluctuation of propeller torque and revolution on the engine characteristics plane. (4) The effect of engine governor characteristics on the propeller load fluctuation.
3.
1990.06
서비스 종료(열람 제한)
In cold season, the developed extratropical cyclones and associated cold fronts, and NW winter monsoon are encountered very frequently in the North Pacific, especially in the northwest part of it. The two sea areas, namely, the northwest part of North Pacific, especially the eastern area far off Japan east coast, and Burmuda Triangle in the North Atlantic are generally known as two of the most dangerous areas in the world because of high incidence of sea casualties. Even large ocean going vessels were sunk frequently due to strong winds and very high seas caused by NW monsoon or developed cyclones during the winter months. The purpose of this paper is to analyse the real state of heavy weather and high sea phenomena on the vesscls at sea, thus helping mariners operate in such conditions.
4.
1990.06
서비스 종료(열람 제한)
In this paper the results for thin multi-layer InGaAsP(1.3μm)/InP crystal growth by vertical liquid epitaxial growing furnance have been presented. The growth rates of InGaAsP layer and InP layer at cooling rate of 0.3℃/min and the growing temperature of 630℃ were obtained as 0.11 μm/min and 0.06 μm/min, respectively, by the uniform cooling with two phase solution technique.
