간행물
Journal of Korean Navigation and Port Reserch KCI 등재 한국항해항만학회지
- 발행기관 한국항해항만학회
- 자료유형 학술지
- 간기 격월간
- ISSN 1598-5725 (Print)2093-8470 (Online)
- 수록기간 1977 ~ 2020
- 주제분류 농수해양 > 해상운송학 농수해양 분류의 다른 간행물
- 십진분류KDC 559DDC 629
권호리스트/논문검색
Vol.10 No.1 (1986년 6월) 9건
1.
1986.06
서비스 종료(열람 제한)
2.
1986.06
서비스 종료(열람 제한)
3.
1986.06
서비스 종료(열람 제한)
Abroad-band design method of a lumped-element 3 dB quadrature hybrid without magnetic coupling is proposed and discussed, where techniques of cascading fundamental hybrids via second-order delay equializers and adding matching sections are adopted. It is shown that the designed broad-band lumped-element 3 dB quadrature hybrid can be easily constructed and its bandwidth reaches up to 54%. Furthermore, the experiments have been carried out, the results of which agree with the theoretical ones, and hence, the validity of the broad-band design method proposed here was confirmed.
4.
1986.06
서비스 종료(열람 제한)
5.
1986.06
서비스 종료(열람 제한)
From time to time the light weight distribution has been discussed, It play an important part in the preliminary design state because of its influence on the available deadweight. Up to the past, the Light weight distribution acting on the ship has been estimated graphically by means of integraph or approximately by the simplified calculations. Recent development has made it possible to use Lloyd's coffin method or Robb's coffin method for Bulk Carrier, Tanker, Cargo ship where the hull weight is distributed based upon the CB The hull weight distribution is then super-composed by number of fixed weights(i.e. machinery , equipment, etc.) The authors built up the method by which the Light weight distribution is calculated using a computer. In the usual calculations, the higher accuracy is aimed at, the longer time would be taken, therefore the accuracy would not be so good as to be expected if the time is restricted. The method using a computer can dissolve these and calculated accurately in shorter time the Light weight distribution with less data.
6.
1986.06
서비스 종료(열람 제한)
Self-contained portable remote-indicating magnetic compass was designed and tested. Its sensing part consists of main scale disk of rotary encoder with photo-etched 180, oopaque slits and three pairs of light sources and detectors seperated by a transparent index scale, so that any angular deflection of main scale disk against the bowl may be detected optically. The outputs from the sensing part are transformed into digital ship's course indication by electronics unit which consists of operational amplifier, phase discriminator, up-down counter and counting starter circuit. The results from testign the above compass with turntable at variable rate of turn are as following : 1) The main scale disk deflection against the bowl can be detected without any disturbing influence to the freedom of its north-seeking function. 2) The digital indication resolution is found to be ˚ ±1 degree. 3) Misrepresenting indication can be avoided by ensuring dimension uniformity and arrangement accuracy of slits on main and index scale disks and by centering pivot in the encoder disk. 4) Indication resolution should be improved by modifying the signal processing and by doubling the number of slits on compass card. 5) Further study should be made on developing non-conductive compass liquid, analogue repeater driving system and more compact processing element.
7.
1986.06
서비스 종료(열람 제한)
Transportation provides an infrastructure vital to economic growth, and it is an integral part of production . As a port is the interface between the maritime transport and domestic transport sectors, it certainly plays a key role in any economic development. Therefore, it is doubtless that inadequacy of a nation's port will depress the level of throughput, to the level where it fails to meet the target set by the national economic planning schemes. Korea is surrounded by the seas and the economic structure of Korea consists of processing trades, so that it cannot be overstated that substantial economy in maritime transport coasts can be achieved through the improvement of the port transport system. This paper treats the transportation process in Pusan Port by Queueing Simulation method, and the reasonable size of Pusan Port is suggested from the point of view of efficiency maximization. The results of the analysis are summarized as follows; 1) the utility rate is 47.91 percents in general piers, 85-52 percents in container piers, and waiting time 5.2hrs, in general piers, 0.8 hrs, in container piers, and the probability of maximum queue length 12 ships in general piers, 2 ships in container piers, and the probability of waiting is 44 percents in general piers, 8 percents in container pier. 2) in general piers, the improvement of app. 30 percents in port capacity is desirable for operating effectively concerning the current arrival rate. By introducing the traffic control ion container piers, there is no apparent necessity of port investment, but I is expected to reduce invisible congestion occurred along the waiting line. 3) On Pusan Port, the optimal utility rate and the optimal arrival rate for reducing waiting time are 3.5 to 4.0(hrs./ship) in general piers, 5.1 to 6.0(hrs./ship) in container piers.
8.
1986.06
서비스 종료(열람 제한)
A matrix partitioning method is proposed for the 2-D motion analysis of floating bodies. For the numerical solution, the boundary of a floating body is approximated with a series of line segments and the governing integral equation is transformed into a system of linear equations. A new solution procedure of resulting linear equation with complex coefficients is formulated and programmed using a matrix partitioning scheme and the Choleski decomposition. From the case study, it is found that the proposed method is efficient in the motion analysis of floating bodies, especially in the calculation of hydrodynamic coefficients. Also, it requires smaller memory size and less computing time compared with conventional methods.
9.
1986.06
서비스 종료(열람 제한)
